Before beginning application, be sure to clean the entire surface of the device with a 100% cotton cloth to remove dust, debris and oily residue.

Step 1

Start by lining up the bottom of the DomeSkin with the bottom of the device using both hands. Make sure it is lined up prior to pressing firmly.

Step 2

Move slowly along the sides of the device gently lining up the DomeSkin with the intended coverage surface areas.

Step 3

Line up the remaining top portion with the surface areas of the device.

Step 4

Check to see if there are any areas that are not lined up correctly, then gently peal up the DomeSkin in those areas and realign. When you are satisfied with the position of the DomeSkin, press firmly on the entire surface to ensure proper adhesion.

Repeat process with opposite sides and remaining DomeSkin pieces. Be sure to line up the graphic patterns on the button dots on the iPod classic and nano.

Step 1

Start by pealing up the edge at one corner of the DomeSkin.

Step 2

Slowly begin lifting the Domeskin away from the device traveling down the length of the device. Continually reposition your fingers to remain close to the device as to not tear or stretch the thin areas of the DomeSkin.

Step 3

When you reach the opposite end of the device, pull the DomeSkin completely off of the device.

Repeat this process with the opposite sides and remaining DomeSkin pieces.

If you are planning on reusing the DomeSkin, be sure to not over handle the adhesive areas. The DomeSkin can lose it's adhesive properties if there is too much oily skin residue and/or debris introduced.

If you are planning on storing the DomeSkin, be sure to re-apply all pieces to the wax paper backing provided with original packaging or household wax paper. Store the DomeSkin in a dust-free bag or container at normal room temperature.